Friday, April 3, 2009

Blade 400 DX6i Binding Instructions

Start with both transmitter and receiver turned off.
1) Attach bind plug to Rx (heli)
2) Turn on the Rx (heli)
--> Light blinking means bind mode.
3) Move sticks & switches to fail-safe positions (Transmitter)
4) Hold the bind button while turning on the transmitter.
--> Tx & Rx should bind after a few seconds. Light on Rx will be solid.
5) Remove the bind plug (heli)
Power off and back on if you want.

1 comment:

Anonymous said...
This comment has been removed by a blog administrator.